Multiecuscan

As the title says is there aby chance to include this ecu in the Fiat ECU Scan's list?
It's from a 1996 1.8 16v Fiat Coupe?
Or at least send me the code for the mpi one and i'll give it a go at modifying it and if I am succesful I will solve my problem and you will get an addon and all the copyrights of course.
Hope to hear from you soon!
All the best,
Cristi

Anyone here? helloo?

It is already included in next version....

Thanks! You're the best!
Keep up the good work!
Best regards,
Cristi

I saw there is support for Hitachi MPI for a '96 fiat coupe but mine has Hitachi MFI.
Any chance for supporting it? I would like to buy the program but what if it's not good for my ECU?

hitman142006 wrote:I saw there is support for Hitachi MPI for a '96 fiat coupe but mine has Hitachi MFI.
Any chance for supporting it? I would like to buy the program but what if it's not good for my ECU?

Did you try to connect to your vehicle? Or to do a scan?
What is the ISO code of your ECU?

I don't know exactly to tell you the iso code but I have a photo of the label that is on the ECU

No I haven't tryed connecting it. It can connect if I don't have the paid version?
I'll try it tomorrow.
All the best,
Cristi

Yes, it can connect with the free version.
But the program will only show the Info screen.

Ok. Thanks for the fast reply. Will try it tomorrow and post the results.
Just one more thing. I have a obd2 to usb cable but I don't have the adapter. I've read that I can simply connect them by wires as follow: obd pin 4 to chassis ground, pin 5 signal ground (black wire pin), pin 5 to K line, and pin 16 to +12V.
Do you happen to know if it will be succesful like that or it's a different configuration?
Thanks in advance and all the best,
Cristi

hitman142006 wrote:Ok. Thanks for the fast reply. Will try it tomorrow and post the results.
Just one more thing. I have a obd2 to usb cable but I don't have the adapter. I've read that I can simply connect them by wires as follow: obd pin 4 to chassis ground, pin 5 signal ground (black wire pin), pin 5 to K line, and pin 16 to +12V.
Do you happen to know if it will be succesful like that or it's a different configuration?
Thanks in advance and all the best,
Cristi

4+5 -> GND
7 -> K-line
15 -> L-line (may be needed for your ECU)
16 -> +12V

K and L lines are the 1st and 3rd pin on the 3-pin connector. The middle pin is GND.