Always disconnecting from ABS
Posted: 18 Jan 2011, 19:13
I tried to connect to the Bosch ABS 5.3 ecu from a 1999 multipla.
Multiecuscan connects to ABS an then it is connected.
After 1-2 seconds the programm disconnects automatically from the ABS unit, an then i am on the start screen again.
Connecting to Engine ecu works without problems, and port and programm settings should be ok, too.
Whats the problem?
I am using the newest version of multiecuscan and a vag kkl interface connected to obd pin 1, this should be ok.
Multiecuscan connects to ABS an then it is connected.
After 1-2 seconds the programm disconnects automatically from the ABS unit, an then i am on the start screen again.
Connecting to Engine ecu works without problems, and port and programm settings should be ok, too.
Whats the problem?
I am using the newest version of multiecuscan and a vag kkl interface connected to obd pin 1, this should be ok.