Multiecuscan

hi guys have twin spark spider. airbag light on .have vag-k-can cable &fiatscan can read ecu ok have bridged pins 7 &3 but cannot get airbag connection all help appreciated

Same problem with my Stilo MW JTD and Multipla JTD. I can connect OK to the engine, ABS, Steering but with the airbag it always comes up with the error "No ECU response, Check your cable and serial port settings".
The "Test" function in Fuatecuscan appears to show a good connection:
COMMAND: ATZ
RESPONSE: ATZ
ELM327 v1.3a
COMMAND: ATE0
RESPONSE: ATE0
OK
COMMAND: ATL0
RESPONSE: OK
COMMAND: ATH0
RESPONSE: OK
COMMAND: ATSPC
RESPONSE: OK
COMMAND: ATS0
RESPONSE: OK
COMMAND: ATCAF0
RESPONSE: OK
COMMAND: ATCFC0
RESPONSE: OK
COMMAND: ATCRA 7B0
RESPONSE: OK
COMMAND: ATSH 7B0
RESPONSE: OK
COMMAND: ATAT1
RESPONSE: OK
COMMAND: ATST41
RESPONSE: OK
COMMAND: ATBI
RESPONSE: OK
COMMAND: ATZ
RESPONSE:
ELM327 v1.3a
>
I have tried all sorts of options in Device manager. I have tried pin 3 only connected to K-line.
Any ideas anyone?

widejon wrote:hi guys have twin spark spider. airbag light on .have vag-k-can cable &fiatscan can read ecu ok have bridged pins 7 &3 but cannot get airbag connection all help appreciated

i think you need a VAG COM KKL cable not a VAG K CAN cable!
i have VAG KKL cable and it is working with airbag ECUs!

and one more thing! you should not connect pins 7 and 3. it is not recommended!
please read this: http://www.multiecuscan.net/HowToUse.aspx (end of the page)