Page 1 of 1
ElmSCAN 5 Timeout
Posted: 01 Oct 2010, 10:21
by Tanis8472
Hi guys,
I've just bought ElmSCAN5 with OBDWiz from Scantool-Direct.co.uk.
I cant seem to test the Elm from within FES. Does it have to be plugged into a OBD in a car to test it?
Drivers are installed from the disk.
It always tells me
COMMAND: ATZ
The operation has timed out.
I have settings set to 115200 in FES and port settings, as its a V1.4 ELM
Help please
Re: ElmSCAN 5 Timeout
Posted: 01 Oct 2010, 12:08
by yani
Try with different port speed.
Re: ElmSCAN 5 Timeout
Posted: 01 Oct 2010, 12:16
by Tanis8472
Port speed where?
COM Port or FES or both?
Re: ElmSCAN 5 Timeout
Posted: 01 Oct 2010, 14:24
by alfa156sarajevo
Tanis8472 wrote:...It always tells me
COMMAND: ATZ
The operation has timed out...
I have this problem when the interface is not connected to the car.
when I connect interface with the car it gives me all info’s:
COMMAND: ATZ
RESPONSE: ATZ ELM327 v1.4a>
COMMAND: ATE0
RESPONSE: ATE0OK>
COMMAND: ATL0
RESPONSE: OK>
COMMAND: ATH0
RESPONSE: OK>
COMMAND: ATSPC
RESPONSE: OK>
COMMAND: ATS0
RESPONSE: OK>
COMMAND: ATCAF0
RESPONSE: OK>
COMMAND: ATCFC0
RESPONSE: OK>
COMMAND: ATCRA 7B0
RESPONSE: OK>
COMMAND: ATSH 7B0
RESPONSE: OK>
COMMAND: ATAT1
RESPONSE: OK>
COMMAND: ATST41
RESPONSE: OK>
COMMAND: ATBI
RESPONSE: OK>
COMMAND: ATZ
RESPONSE: ELM327 v1.4a>
Re: ElmSCAN 5 Timeout
Posted: 13 Oct 2010, 22:33
by EnIgMa
alfa156sarajevo wrote:Tanis8472 wrote:...It always tells me
COMMAND: ATZ
The operation has timed out...
I have this problem when the interface is not connected to the car.
when I connect interface with the car it gives me all info’s:
CUT
it's not a problem, elm device need electricity so it's powered by the car, not from the computer.