Multiecuscan

my 156 from 1998 1.6 TS his airbag light is burning and i can`t reset it. it says code 01 and that internal components in the ecu may cause this or lack of mass or + voltage.

i soldered the wire under the non-driverseat.

i checked all wiring and plugs

there was a loose plug near the airbagmodule(ecu) and that was an error 0B , but the nice thing was i could reset that one, so now there is only the above mentioned.

am i in need of a new module than?

please help

thanks and greetings,

Wynand

01 Airbag control unit
If all connection to your Airbag ECU are good then you have one choice: Change the ECU becase is damege.
I had same error on my wife's car and I didn't try to check anything. I just change the Airbag ECU and everythings it's working now.
If you have possibility to change the Airbag ECU without pay for it first will be the best for you. I had that chance and i didn't work to check all the connector or the wires.
So good luck

i agree with mattydr67. it is probably the Airbag ECU!

alfa156sarajevo wrote:i agree with mattydr67. it is probably the Airbag ECU!

that fixed it!!!!

thank you guys!