Multiecuscan

Hi!

I tried Multiecuscan with kkl interface and working fine! Very good software with many functions!!!!!

My question: possible to add mobydic interface to multiecuscan? OE90C2800 lite chip or OE90C2600? This chip can handle ISO and CAN protocol too, like elm chip.

Other: i have fiat brava from year2000 and the ABS with ATE TEVES ecu. I didn't find any program for communicating with this ecu. Only BOSCH and Lucas ecu supported:(

Thanks!
regards
Tom

Do you have an interface like this?
I asked you that because I have one too and the guys who made the sw for it said that it dosen't support any CAN that's why the manufacturer of the chip ( a turkish company) said that they didn't made this interface.
So if the Yani wants to try I can give the all material I have about this interface.
The chip has an multiplexor inside so you don't need to make one outside with DIP switch.
Yani can try if he like to.
Good luck
P.S. What sw do you use with your interface? Fiat Finalist 1.0 or Fiat Finalist 116? Thanks

Hi

I have OE90C2800 based interface. Finalist software use special chip, OE90C2620 specially for FIAT.
I use MODIAG and and Allpro v4.1(hungarian software only). This softs use OBD commands, not car specific commands.
This interface first search communication protocol, if found, green led turned on, if not found green led blinking, and the chip can send receive bytes.
All comminication commands for this chip available in the document. Downloadable from the chip supplier.
At this moment i can't try CAN protocol, my car use kwp200 fast init. (engine ecu only marelli IAW 4EF). ABS and AIRBAG not supported by modiag and allpro...

regards
Tom

Ok TOM
I suppose that you have Fiat dedicated interface, because I have one andhow I said I think the CAN it is not supported by it.
I will try to speak with Yani about that and if he needs i will send my interface to and data file to see if he can do something.
B/R
Dragos