Multiecuscan

I'm using the eval version. I install the driver that was provided with the interface all is OK I do a connection test and I get the output below:-


COMMAND: ATZ
RESPONSE: ATZ



ELM327 v1.4a

>

COMMAND: ATE0
RESPONSE: ATE0

OK

>

COMMAND: ATL0
RESPONSE: OK

>

COMMAND: ATH0
RESPONSE: OK

>

COMMAND: ATSPC
RESPONSE: OK

>

COMMAND: ATS0
RESPONSE: OK

>

COMMAND: ATCAF0
RESPONSE: OK

>

COMMAND: ATCFC0
RESPONSE: OK

>

COMMAND: ATCRA 7B0
RESPONSE: OK

>

COMMAND: ATSH 7B0
RESPONSE: OK

>

COMMAND: ATAT1
RESPONSE: OK

>

COMMAND: ATST41
RESPONSE: OK

>

COMMAND: ATBI
RESPONSE:
ERR94

>

COMMAND: ATZ

I then try a connection to the body computer and I get a ELM327->ECU connection error. Any Ideas?

I made a Post in the Stilo section and have had a reply saying its most likely because my cable doesn't have a genuine chip? Well I've got my eyes on another one on ebay so will buy that and give it a go.