Multiecuscan

hello yani,

i´m driving a fiat croma 1,9 multijet 8v (120 PS) from 2006.

i`m using a registered version of your fiat ecu scan 2.3.1. and an ELM327 V1.3a Interface.
Which function must i use if i want to replace a new egr by myself. I think after replacing the egr i have to learn the new egr. How can i do this whith your software ? Is it right that the egr is 4% open if the engine isn´t running ?

Secondly my throttle (i think you use the word shutter valve) isn´t working. (always open 5 % from fiat ecu scan diagnosis) The actuator diagnosis of the throttle/shutter valve brings a fault.

Where can i buy a new throttle/shutter valve ? Maybe only the actuator and electronic of the throttle may be defect. Is it possible to buy only the actuator of the throttle. I think there are some clips to disassemble the bottom of the throttle/shutter valve.

Sorry for my English. Nevertheless i hope you will understand me.

Ciao FrankyNue

Maybe this way? BAS

Hello,

thank you for your hint.

Is it possible after choosing the point "reset self learnt functions" to select the part that i have changed (e.g. the EGR or throttle). I´m a little bit angry to select this menu point whithout knowing what happens afterwards.

I´m right that the ignition must be cut of for 40 sec. after starting the procedure to zeroing the new parameters of the changed part ?

Ciao FrankyNue