Ducato 250 , Steering angle sensor check with MES
Posted: 07 Jul 2024, 22:42
My Ducato 250 Display show up some failure , like .... Hill Holder , ESC not availabale.
I made with the MES the calibration of the longitudinal /lateral acceleration sensor and for
the steering angle sensor. After those calibration procedure I can see the graph diagram in the MES parameter function when I shake the car.
But I don´t see an graph reaction in the MES parameter when I turn the steering wheel.
No failure report during steering angle sensor calibration, but no reaction in the parameter graph funtion. ( steering angle sensor enabled during test )
Must I fit a new steering angle sensor in my car.
I made with the MES the calibration of the longitudinal /lateral acceleration sensor and for
the steering angle sensor. After those calibration procedure I can see the graph diagram in the MES parameter function when I shake the car.
But I don´t see an graph reaction in the MES parameter when I turn the steering wheel.
No failure report during steering angle sensor calibration, but no reaction in the parameter graph funtion. ( steering angle sensor enabled during test )
Must I fit a new steering angle sensor in my car.