Multiecuscan

Invalid ISO code:

I tried the simulation mode (unregistered version 2.2.1) CTRL-F10 on a ALFA159 JTD16V.
I'm using a bleutooth elm v1.3 (clone)
Everything works fine when accessing motormanagement CPU bosch EDC16C39.
When "accessing" airbag, valeo parking control and service reset I'm getting the message "Invalid ISO code".
Is this normal (in the unregistered version)? Or wil I get the same message when I buy a registered version? (So it is a "bug").

try to connet it for real.
I always get Invalid iso code when i use it in demo version...but when i sue it with my car it works great.

bluetooth version is not too good!

Please look at the topic Board index ‹ General < Multiecuscan 2.3 RELEASED!
Yani wrote: "Improved ELM327 Bluetooth support, but still too unstable and not recommended"