Multiecuscan

Dear MultiEcuScan loivers and users. I have puchased a license yesterday so the programm fully works
My question is i hava a 2010 fiat panda 169 euro 5 with 1.2 engine 69hp, removed the electrical steering to replaced with a none electric steering. (trackday related) Mechanicly everything works fine, but i want to know if it is possible to remove the eps out of de ecu so the warning light doesnt show up, Thank you for your time and effort

Turned out to be very easy. :ROFLMAO: with original Multiecuscan software registered, and a good elm327 dongle.
No adaptercables needed
Removed the powercables from the power steering. So the light of fault EPS turned on, left the datacables intact on the eps-ecu.
New proxi alignment procedure,save, and now it says : powersterring not present, no erros or fault codes, and the city knob is deactivated,
Scanning for fault codes,
No faultcodes turn up, yes, yes, Yes