Multiecuscan

Cool Eddy,

one more thing.

I would need these cables in order to read all info I am looking for. http://www.aliexpress.com/item/HK-post- ... 89225.html

If I buy this three cables, green tip goes to OBD socket in my cara, and black tip goes to elm327 bluetooth and then I would be able to read airbag?

Hello

No no no Dragonus

Your airbag control unit does not work with an ELM interface to read
whatever adapter cable you are using
It does not work

Buy you access this KKL interface and you can order on your airbag
without a red adapter cable to use
At position 3, you come to your bag

http://www.ebay.de/itm/151015653820?ssP ... 1438.l2649

Send the seller a greeting from me



With the cantie or OBDkey interface to connect to the airbag is also possible
but they cost much more

Greetings Eddy

Hello Alfaeddy

do you maybe know something about J1850 PWM OBD2 protocol?
I have ELM327 v1.5 mini adapter like this one


and I have a problem when trying connect to the ECU on my car (Ford Focus 2001 1.4 16V)
On other cars with different protocol it works, but with J1850 PWM protocol it does not working...

I found a solution for a different model here

http://www.talkford.com/topic/194099-el ... ?p=1845018

So I wonder if somethings like that would be possible on this smaller model, or should I buy the bigger one and hope it can be repaired this way?

PS
I can't open the device because of possible money refund
First I am interested in your opinion...
If it helps PCB are soldered together, it can't be easily separated

Hello

With this protocol, unfortunately I do not know myself, sorry
I thought that this protocol is not used in Europe.

Only should the mini-ELM can read this report !
Which diagnostic software do you use?

My father has a '03 Ford Focus and this is read via KWP 2000
not on SAE J1850

Greetings Eddy

My car was manufactured in Germany.
I have the following pins on the car connector: 2,4,5,7,10,13,16
PWM Protocol uses 2 (data), 5 (ground), 10 (data), 16 (power)
My friend can connect to my car with his diagnostic tool, and read it through the PWM protocol.
I tried a lot of software on my android smartphone, and on pc i tried with scanmaster, multiecuscan, scantool.net...
This adapter works great with my second car, but it doesn't want to work on ford.
I'll try to buy another adapter and see if it works.

Hello

What is your second car?

I think the fault lies more in the software than on the Ford
Could you ever read the Focus with ScanMaster or scan tool?


Greetings Eddy

Opel Astra is second car.
I found that many of these devices are based on the same, incorrect, PCB layout. This layout contains a mistake which means that the J1850 interface doesn't work.
They have the T5/T2 transistor tracking fault on PCB which in other models can easily be removed, but in these small adapter that is not the case.
And yes, ScanMaster can read Focus, but that was tested before with USB Diagnostics, not bluetooth..

Hi Friend.

I have a trouble problem with connect my elm to grande punto 1.4 8v. It's connecting just engine. I also own yellow adapter but still no luck.

this interface

this is interior of interface

ello Agila


Remove the red resistor and let this place open
it is the interface with CAN bus capable Multiecuscan

Greetings Eddy

can i use wallpaper knife to remove it I dont own soldering iron?