Multiecuscan

So, I've tried to bridge together pin 7 and 12, and the results are:

1) Alfa: nothing appens... Can't connect with xeno ecu...
2) 500: can't connect with anything!!

So, the 500 won't 7 and 12 bridged together...

But for my Alfa I've a doubt: Is that impossible to connect with xeno ecu because they (xeno headlights) weren't installed on my car at the beginning, but I've purchased them after?

Racing Man wrote:So, I've tried to bridge together pin 7 and 12, and the results are:

1) Alfa: nothing appens... Can't connect with xeno ecu...
2) 500: can't connect with anything!!

So, the 500 won't 7 and 12 bridged together...

But for my Alfa I've a doubt: Is that impossible to connect with xeno ecu because they (xeno headlights) weren't installed on my car at the beginning, but I've purchased them after?

KKKK, forget it! By the way, why connect with it anyway?

Because it doesn't work anymore high regulation of right one... And I'd like to see if via MES I can do something...

On elearn I've seen that there's a pin on xenon headlight connector that goes on body computer. But I don't know if there's that connection without xenon from the factory...
I've try to figure it out!!! Stay tuned!

I think you will only waste time...

Waltomatic wrote:I think you will only waste time...

Almost for sure!!