Multiecuscan

Hi Lolo85v

I cant see the numbers from the Chip
where ist the Chip MCP2551 ???

Please make a image without flash

Have an Makro Modus in your Kamera ??


Greetings Eddy

Hi Lolo85v

I see you have an Alfa 159


Can so you have a connection to the engine control unit
That must always work on Alfa 159
Otherwise, your error is a setting error!!

Greetings Eddy

Here were better one photo the friend the flea(chip) mcp2551i

http://i69.servimg.com/u/f69/13/77/86/13/20130416.jpg

http://i69.servimg.com/u/f69/13/77/86/13/20130417.jpg

Hi Lolo85v

Answer me look at my question!
Can you make a connection to the ECU?

And the board has no problem with the CAN bus

It should work without problems


Greetings Eddy

Not of connection has the ecu

Hi

Then I have to say it again again again
It's not the Problem with the ELM interface!!!

check
- driver
- settings
- COM port

Greetings Eddy

Hem I have to try several computer experimental plusieur I have this message has the connection ecu on the other hand I arrive has to connect me has bodysuit

I really have no luck(chance)

http://i69.servimg.com/u/f69/13/77/86/13/sans_t12.jpg

With that her(it) you to confirm me that he(it) is functional?


http://www.ebay.fr/itm/CAN-327-Interfac ... 3373ff4313

Hi Lolo

Yes it works Guaranteed
If software, drivers, and settings are correct

Send the dealer a greeting from me (EDDY)

But your OBD interface should also work

Greetings Eddy

Here is it is to command(order) on the other hand for my elm they it connects everything has modulates them except driving thus can being one resistances is missing?