Multiecuscan

hello in the future will support air-conditioning and alarm system?? for bravo (182)

thanks

yani wrote:Please be patient! I'm working very hard to release v2.0.

As far as I know Fiat Grande Punto (2007) is CAN-only. You cannot do anything with VagCom cable. You'll need ELM 327.
However, it will not be supported in v2.0. I'll add support for Grande Punto soon.

Yani

Great! Great!

Just, i didn't understand if we will have to modify the cable of elm-device as we do for the vagcom cable or not.

thank you!

More than likely if the pins are not connected
I have a Gendan Elm and it will need altering
to work.

John

Gendan Elm Interface

Care to clarify? Why would this interface require modification?

Gendan Interface needs altering as not all the required
pins in the diagnostic socket are connected for diagnostics.
Same as the VAG.

John

Hi
need translate to Chinese?
I can help

Regards

Tried to connect via ELM 1.5a, but it didn't work. So I have ordered an ELM 1.3 and hope, that it will work to reset the Service message at my Stilo 1.6...

Kay

mike1327 wrote:Hi Yani! Will version 2.0 support ABS Teves Mk20 for Fiat bravo 1.9JTD, 1999

Your vehicule was made after 1998 so it's not anymore a TEVES MK 20 ABS, but a BOSCH 5.3 ABS.

I give you a tip to easily reconise your abs type :

- TEVES MK 20 : On the front wheels, the sensor rings are positioned on the transmission drive shaft



- BOSCH ABS 5.3 : On the front wheels, the sensor rings are in the bearing seal