Page 4 of 4
Re: Multiecuscan 2.6 RELEASED!
Posted: 02 Dec 2010, 21:16
by cicus
same problem with GrandePunto 1.9 Mjet..i've send the report!
I've the ELMScan 5
performance de multiecuscan
Posted: 03 Dec 2010, 02:33
by adão carlos vieira
With multiecuscan, 2.6, tested the fuel injection of a SIENA FLEX 2010/2011 was excellent, ECU IAW 4GF,
Re: Multiecuscan 2.6 RELEASED!
Posted: 03 Dec 2010, 07:11
by yani
Please read this info about Grande Punto/500/MITO/Punto Evo.
There is a problem with some ELM interfaces and these vehicles. Many people can not connect to the engine ECU.
The problem is completely resolved now and I'm preparing version 2.6.1 and will probably publish it in a few days. It will work properly with all ELM327 interfaces.
There was also a problem with the "Scan" function in version 2.6 which is also resolved in 2.6.1.
There is one more thing to mention about these vehicles. In order to access some modules (like Service Interval Reset) you need a modified ELM327 interface. The two CAN lines which are originally connected on pins 6 and 14 should be moved to pins 1 and 9. DO NOT SHORT pins 1-6 and 9-14.
Re: Multiecuscan 2.6 RELEASED!
Posted: 03 Dec 2010, 08:06
by yincar
Hi Yani,
The two CAN lines which are originally connected on pins 6 and 14 should be moved to pins 1 and 9. DO NOT SHORT pins 1-6 and 9-14.
Question: Does this mean, we have to disolder the original Pin 6, solder to new location Pin 1. Then disolder pin14 and solder to pin9?
thanks.
Re: Multiecuscan 2.6 RELEASED!
Posted: 03 Dec 2010, 10:49
by yani
yincar wrote:Hi Yani,
The two CAN lines which are originally connected on pins 6 and 14 should be moved to pins 1 and 9. DO NOT SHORT pins 1-6 and 9-14.
Question: Does this mean, we have to disolder the original Pin 6, solder to new location Pin 1. Then disolder pin14 and solder to pin9?
thanks.
Yes, unfortunately, this is exactly what I mean.
In these vehicles pins 1 and 9 are for the low speed can bus and pins 6 and 14 are for the high speed can bus. You cannot short circuit the low and high speed lines.
Yani
Re: Multiecuscan 2.6 RELEASED!
Posted: 03 Dec 2010, 13:26
by ermpanta
We could make a cable between the elm and the diagnostic port with the pin already reversed?
Re: Multiecuscan 2.6 RELEASED!
Posted: 03 Dec 2010, 13:41
by ermpanta
hi yani can you post a pictures with the change to do thanks.
Re: Multiecuscan 2.6 RELEASED!
Posted: 03 Dec 2010, 14:22
by adão carlos vieira
The la, Yani, thanks for the new version of multiecuscan,
ta great, works on all flex Fiat, Fiat in Brazil after 2003, are all bi-fuel (flex) to fiat already manufactured 2,500,000 flex-fuel cars,
Re: Multiecuscan 2.6 RELEASED!
Posted: 05 Dec 2010, 21:06
by piscinarasx
What is the Proxy Alignment Proceedure? thanks