Page 136 of 255
Re: FAULTY ELM 327 INTERFACES DE-MYSTIFIED (READ HERE)
Posted: 18 Aug 2014, 10:38
by dafe
Alfaeddy wrote:Hello Zafron
Your pictures are very very very bad , Sorry
In the first picture of the Mini ELM I can not see anything
The upper board is installed, the you need can pull off
You should not use flash when taking photos.
But again, the bridge resistance only affects CAN bus protocols
So the Punto of 2000 must be read with the resistance MotorECU.
Greetings Eddy
This resistor right?
Re: FAULTY ELM 327 INTERFACES DE-MYSTIFIED (READ HERE)
Posted: 18 Aug 2014, 10:57
by Alfaeddy
As I have already written, I know only the plug contacts
to be separated without soldering
Greetings Eddy
Edit:
The ELM of Zafron is also plugged, with a slight train and move back and forth, there should be separate
Re: FAULTY ELM 327 INTERFACES DE-MYSTIFIED (READ HERE)
Posted: 18 Aug 2014, 11:39
by dafe
I'm afraid of break all pulling it strong but i'll try.
Re: FAULTY ELM 327 INTERFACES DE-MYSTIFIED (READ HERE)
Posted: 18 Aug 2014, 12:27
by zafron
I think my elm is really soldered, not plugged. I will try move it back and forward.
Edit: Doesn't work unless I brake the connectors. I think I will sawing them.
Re: FAULTY ELM 327 INTERFACES DE-MYSTIFIED (READ HERE)
Posted: 18 Aug 2014, 12:59
by dafe
In fact i think i'll unweld the pin
Re: FAULTY ELM 327 INTERFACES DE-MYSTIFIED (READ HERE)
Posted: 18 Aug 2014, 15:41
by Alfaeddy
If the pins are not plugged in
then unsolder the pins on the top board
Greetings Eddy
Re: FAULTY ELM 327 INTERFACES DE-MYSTIFIED (READ HERE)
Posted: 18 Aug 2014, 17:11
by dafe
I know it could seem strange but the pins are plugged in but it's impossible unplug them. I also tried with a vice and pull with a tongs!
Re: FAULTY ELM 327 INTERFACES DE-MYSTIFIED (READ HERE)
Posted: 18 Aug 2014, 17:30
by Alfaeddy
Oh dear, with a vice or pliers ???
These are not tools to work on boards
Greetings Eddy
Re: FAULTY ELM 327 INTERFACES DE-MYSTIFIED (READ HERE)
Posted: 18 Aug 2014, 18:28
by dafe
Don't worry obiouvsly i took the caution and ddin't damage nothing. I only made you understand that pulling wasn't enough.
Re: FAULTY ELM 327 INTERFACES DE-MYSTIFIED (READ HERE)
Posted: 18 Aug 2014, 20:27
by Alfaeddy
Ah ok , i understand it
Greetings Eddy