Multiecuscan

lolo85v wrote:Good evening can you tell me on what(whom) position the kkl has to be for the reset drain away on 159? Thank you

I have to try quite position but its pass not

???????


Greetings Eddy

What position of swicht kkl for draining alfa 159? Thank you

Hello lolo85v

The KKL interface you can only read the engine ECU with an Alfa 159
nothing else (ok well the ABS)

Therefore, you need not switch the KKL interface but only a bridge from
Pin1 to Pin 7

For all other controllers you need an ELM interface

Greetings Eddy

Thus for the reset draining I has to make a bridge(deck) between 1 and 7?

http://i57.servimg.com/u/f57/13/84/33/82/20131212.jpg

Hello Lolo85v

For draining?? what you mean?

Ok now i understand, you have a switched KKL Interface
from this interface you must not make a bridge from 1 to 7

Everything OK

It is difficult for me to translate your post


Greetings Eddy

I use a translator

lolo85v wrote:I use a translator

Hello lolo85v

Now I understand why I can not read your posts


Greetings Eddy

Hello guys. I need your help. Can i connect VAG KKL with mine Fiat Grande Punto. I was read that, it will not work. But i ordered it. What can you say. Thank you for answers)

Hello Monax

You need an ELM Interface and an Adapter A3 ( yellow) for the Grande Punto
With your KKL Interface can´t nothing read any control

All controls in Grande Punto read in CAN Bus and KKL can not read CAN Bus


Greetings Eddy

Eddy Thanks for answer. My order is failed. Minus 16$ for me(( Now i know that i need only ELM