Multiecuscan

90 seconds only contact without touching everyting -> switch off for 90s. -> 90s. idle without touching everyting

OK, here is a clearer version of what worked for me:
Connect ELM 327 USB cable between ECU and laptop
Turn ignition key to On
Start laptop
Start multiecuscan
Ensure Settings are ELM 327, COM4, 38400
Connect
Check Errors then Clear
Execute Self-adaptation Reset
Disconnect cable
Warm up the engine, increase the RPM to 5000 three times for 10 seconds each time, at which point the flashing and beeping should stop, then turn the engine off for at least 2 minutes.

Hope this helps.

frankgilbert wrote:OK, here is a clearer version of what worked for me:
Connect ELM 327 USB cable between ECU and laptop
Turn ignition key to On
Start laptop
Start multiecuscan
Ensure Settings are ELM 327, COM4, 38400
Connect
Check Errors then Clear
Execute Self-adaptation Reset
Disconnect cable
Warm up the engine, increase the RPM to 5000 three times for 10 seconds each time, at which point the flashing and beeping should stop, then turn the engine off for at least 2 minutes.

Hope this helps.

I agree with frankgilbert
i did t on few Stilo's and it worked just fine...