Multiecuscan

sdmaino wrote:Jumped from 3.4 to 3.6 and DRL settings for fremont are not working anymore.
Reverting back to 3.4 and all works OK.
Still did not test 3.5
Thank you for fixing

Please tell me which version works. A service technician tried to activate the DRL with v3.6 on Freemont with Uconnect 4.3, FWD with manual transmission. He couldn't activate it because some kind of error popped up. He said he wasn't sure that this configuration is supported. Does anyone know or was able to activate the DRL on Freemont with Uconnect 4.3, FWD with manual transmission.

It worked for me and i could enable and the settings are : DRL enabled / Canada / High Beam / 6,8v
I don't know the difference between Europe 1/2/3 seems to be UK / W. Europe / E. Europe

haffonso wrote:It worked for me and i could enable and the settings are : DRL enabled / Canada / High Beam / 6,8v
I don't know the difference between Europe 1/2/3 seems to be UK / W. Europe / E. Europe

Do you have 4.3 (small screen) or 8.4 (big screen) Uconnect? Manual/Auto and FWD/AWD?

i have uconnect 8.4.. but there s nothing to do with uconnect.. this is the bcm module..
go to body module and adjustments.. the scanner should be multiplexed or with the connector mentioned in multiscanner site

no issues at all..
To configure DRL using the uconnect settings

Drl enabled
Drl Settings Europe 3 and not Canada... unless your country requires the headlights on all the time

voltage.. 7.0v but you can see the most convenient which is 24% of power consumption. you can see it in parameters in multiscanner..

find the screen whre the drl should be configured
for Canada choose Canada.. if wish to control from uconnect use Europe 3.

Thanks a lot for the information. Can you take a picture of the Uconnect menu and settings when Europe3 is enabled.

https://youtu.be/7E8uKUM9Aas

find the link

Just wonder how it is going to look on 4.3 screen.

haffonso wrote:find the screen whre the drl should be configured
for Canada choose Canada.. if wish to control from uconnect use Europe 3.

If you choose Europe 3 where in the Uconnect menu the setting to control DRL shows up.

I've just activated the DRL with latest v3.7.