Multiecuscan

Can you make the rev counter and speedo do a test upon turning the ignition on?

steedy27 wrote: Think he means when you open the car from locked the front and rear lights like follow me home automatically come on.

Yup - Like you get on BMW/Audis ect. Usually it's Side lights/rear lights/Numberplate lights

Also is it possible to permanently disable the ASR so it is always off?

TomJL wrote:

steedy27 wrote: Think he means when you open the car from locked the front and rear lights like follow me home automatically come on.

Yup - Like you get on BMW/Audis ect. Usually it's Side lights/rear lights/Numberplate lights

Yeh would be nice to have this!

steedy27 wrote:

EnIgMa wrote:you can already turn off the buzz.

Thanks is there a user guide on how to do this?

I don't mean to be rude but, why don't you try the software first, then ask?

Anyway, for seat belt buzz you have to connect to dashboard module, then Adjustments, there you can activate/deactivate the buzz.
Well, the great thing is if you disable the buzz it will be available on the dashboard menu.
So, in the future, if you want to re-activate/de-activate the buzz again, you can do it directly on your car without using FES

Lal B3N wrote:Also is it possible to permanently disable the ASR so it is always off?

It would be great

I am really excited with the functionalities of this little app. However I have had no luck using it since as it seems my vehicle is not supported....So the big question for me would be:
will you be adding support for the Grande Punto StarJet Engine (1.4 16V CF4 95bhp - MY2007) - engine ECU is Bosch Motronic MeD7.6.3 CF4/EOBD.

Thank you

TomJL wrote:
- Is it possible to activate the auto open/close windows when holding down the lock/unlock on the car key for the GP?

This functionallity is available only in 5 doors car when all windows are electrically steering.
There are different motors in 3 doors basic version, 3/5 doors high equipment version and 5 doors electrically steering. It is possible to do, but there are need changes in main switch for windows and replace motors in doors and making few wires...

new request

is it possible to activate/deactivate the check of tyre pressure?

Just disconnect connector from Tyre pressure module, which is localised on the right side of boot, under place when is / should be installed subwoofer. Then get Proxi.

Or simpler. In boot on left side there is Fuse box. Remove third fuse on right side from bottom, 10A. This fuse is for power to this module. Of course after this, you should do Proxi.

Thank you.

but, is it the right way?
or i'll get an error stored somewhere?