Grande Punto Cruise control aftermarket

[TLM]

a up of this topic. If someone with a GP 1.3MJT with cruise control can send his logs to help up to finish the install

A lot of GP 1.3MJT seems to have the connector by default. That will help a lot of personnes!

Thanks

[Thibag64]

The installation and activation of the aftermarket CC has been done on this Italian forum so it is possible:
http://www.grandepuntoclub.com/forum/vi ... 32&t=33450
I don't speak Italian but I understood that they used a software called "Leonardo" to activate the CC.

[EnIgMa]

Yep.

[Thibag64]

I've just tried the new version (3.04) of FES. It seems possible to install the CC by doing a "zeroing" of the engine ECU.
The zeroing works (I see the action on gearbox detection) but the CC is still not recognized.

EDIT: OK, I had not seen that the CC could be activated via proxi alignment. I will try this and give feedback.

[Thibag64]

OK, CC is now activated on my car.
Thanks yani for implementing this function!!!

[Lal B3N]

OK, CC is now activated on my car.
Thanks yani for implementing this function!!!

What was needed then? Just a CC stalk? Was all the cabling there already?

[Thibag64]

I described the complete process on this french forum:
http://puntomag.fr/viewtopic.php?f=11&t=4986

You need to change the complete switch and I had to add a cable between switch pin 8 and OBD pin 41. The cabling is already there on some cars.

[Lal B3N]

I described the complete process on this french forum:
http://puntomag.fr/viewtopic.php?f=11&t=4986

You need to change the complete switch and I had to add a cable between switch pin 8 and OBD pin 41. The cabling is already there on some cars.

Thank you. Ahh sounds complicated, shame i don't know anyone in the UK who has done it.

[holbli]

Hi Thibag64,

i did the same: i installed the steering column switch and activated the CC. During proxi alignment i get the following failure:

*************************************
WARNING: This vehicle is properly configured. PROXI Alignment is not needed!
EXECUTING ADJUSTMENT...
Cruise control
Old value: Disabled
New value: Enabled
COMPLETED


EXECUTING ADJUSTMENT...
PROXI Alignment Procedure
Writing CAN configuration data ...
Writing to module: Body Computer Node (NBC) SUCCESS!
Writing to module: Dashboard Node (NQS) FAILED! - Request out of range error
Writing to module: Airbag Node (NAB) SUCCESS!
FAILED TO EXECUTE
Request out of range error
*************************************

now CC is working fine, but the CC indicator in the dashboard doesn't work and my odometer value is flashing.
Did this also happen to you?


thx

[Thibag64]

The CC indicator on the dashboard doesn't work for me either. May be there is a missing cable to add. I didn't get the dashboard flashing. I did also a "zeroing" in the engine module.