Multiecuscan

yani wrote:

illiac4 wrote:Hi! Will 'Added cruise control re-learn function for EDC15C7' work on Alfa 159 with no cruise control by default and after placing cruise control switch into the car and to present them?

No, it is for vehicles with EDC15C7 ECU only. I will check the documentation for other ECUs and add it in future versions if possible.

Please check if it is possible to turn on the led on dashboard in stilo when cruisectrl is on.

BAS

bas wrote: Please check if it is possible to turn on the led on dashboard in stilo when cruisectrl is on.

BAS

Stilo with which engine?
If you have 1.9JTD with EDC15C7 then you can try this function.

Yani

yani wrote:

bas wrote: Please check if it is possible to turn on the led on dashboard in stilo when cruisectrl is on.

BAS

Stilo with which engine?
Yani

1.6 16V 192_XB1A

Pozdrawiam BAS

bas wrote: 1.6 16V 192_XB1A

Pozdrawiam BAS

This function is already available for your engine.
Go to Adjustments and execute "Vehicle configuration reset". Then your ECU will be forced to re-learn the gearbox type, climate control, cruise control, ABS, electric steering.

Yani

I just tried new version but when I want to connect to any module it says that it is only possibly with registered version and in simulation mode. Is it more restriction than in older version or somwhere is other problem?

sime wrote:I just tried new version but when I want to connect to any module it says that it is only possibly with registered version and in simulation mode. Is it more restriction than in older version or somwhere is other problem?

There are no additional restrictions.
Which module did you try? The free modules are with black font on http://www.multiecuscan.net/SupportedVehiclesList.aspx

yani wrote:
Go to Adjustments and execute "Vehicle configuration reset". Then your ECU will be forced to re-learn the gearbox type, climate control, cruise control, ABS, electric steering.

Yani

OK, I checked,
- key position: MAR,
- cruisectrl switch: ON,
I executed "Vehicle configuration reset" but it still does not work(i made a road test, cruisectrl works but the led on dashboard is still off)

BAS

Hi Yani,

great work. Thanks!

So far I used V2.0 (bought license). Can I use the same license data for V2.3 in case the software is installed on the same PC?

Secondly, is it possible and/or will be possible to install the software on a USB stick?

Thanks for your reply.

BR,
Frank

fs1958 wrote:So far I used V2.0 (bought license). Can I use the same license data for V2.3 in case the software is installed on the same PC?

Yes, the License Key is valid for all versions.

fs1958 wrote:Secondly, is it possible and/or will be possible to install the software on a USB stick?

You can install it whereever you want. It should work on anything that acts as a logical disk drive under windows - hard drive, SSD drive, USB stick, memory card, etc.

Yani