Alfa mito 1.4 tb 155cv (works with adaptor nº1?)

[pues]

Hello,

I´m an owner of Alfa mito 1.4 tb 155cv.

To activate xenon in this car, i need to use adaptor nº 1 for this car, but im questioning if i could use this adaptor because this have a shortcut between pin number 1 and 9 and in this faq( http://www.multiecuscan.net/SupportedVehiclesList.aspx) says that be careful with this kind of cars, may cause a problem using this adaptor in some cars.

may really cause a problem, or i can use without problems?

Thank you very much in advance.

[yani]

PLEASE DO NOT USE ADAPTER 1 IN MITO! This is an error on the supported vehicle list page.
The Xenon module is on pin 12 of the OBD connector on Mito. But you cannot use "Adapter 1" in Mito as it has short circuit between 1,9 and other pins and that may cause damage.
You need to use the Yellow adapter (actually, the yellow adapter from Gendan has pin 12 connected to pin7).
I will correct the wiring diagram of "Adapter 3" as it needs to have a wire between pins 7 and 12. This is definitely an error in my "SupportedVehicleList" page.

If you don't have this Yellow adapter then you can make a short circuit between pins 7 and 12 and use it for the Xenon module.

[Juggers2k]

Yani - just a reminder - it looks like you've updated the adaptor 3 diagrams, but the mito listings still say to use A1 at the moment.

[yani]

It is updated now.

Thanks!