Which pin interface and the xenon headlights will be read?

[Alfaeddy]

Hello
Unfortunately I can not see in the list of vehicles with which interface and which pin the xenon headlights is read.

Is needed in the list, only the adapter from A1 (green).
So I think that it is not read via the CAN bus.

Can someone help me?

Thanks and regards
Eddy

[yani]

You need to connect to pin 12 for the Xenon module.

[Alfaeddy]

Hi Yani

Thanks for your quick response.

It is safe to read only with a ELM interface?


Greetings
Eddy

[yani]

It is safe to read only with a ELM interface?

You can read it with any interface - KKL, ELM, OBDKey.
However, if you are using KKL (VagCom) interface you will probably have to set "KWP2000 Timings" (in Settings) to "Default".

[dallas140cv]

In the "Supported vehicles" list, all xenon projectors interfaces is specified only as "A1", without any other type. Can you correct this, please?

[yani]

In the "Supported vehicles" list, all xenon projectors interfaces is specified only as "A1", without any other type. Can you correct this, please?

Yes, I will correct it...

[Alfaeddy]

It is safe to read only with a ELM interface?

You can read it with any interface - KKL, ELM, OBDKey.
However, if you are using KKL (VagCom) interface you will probably have to set "KWP2000 Timings" (in Settings) to "Default".

Thank´s for you


Greetings

Eddy