Multiecuscan 2.1 released!

[yani]

Hi,

I just released version 2.1. The main difference from 2.0 is that the commercial version registration is now available.
I also added Service Interval reset for Alfa 147, GT, Fiat Punto, Panda, Idea, Doblo, Lancia Musa...
I tried to fix the problem with Airbag connection which some of the users are experiencing.
I hope that you will not need to "Run As Administrator" anymore.
You will need to uninstall version 2.0 before installing 2.1.

I'm not ready with the updated "How to use" section, so here are some notes for the features of the commercial version:
- When you press Ctrl+F10 to connect to a module the connection is started in simulation mode (no cable is needed).
- To select a "template" on the Parameters screen press any key between 0 and 9.
- To save a "template" on the Parameters screen press Ctrl+ any key between 0 and 9.
- To insert a "tag" when recording data on the Graph screen press any key between 0 and 9.

To register:
1. Start the program.
2. Click "Register" button (left-down, above Settings button)
3. Copy the Hardware Key.
4. Open you internet program and go to the registration page on my site - http://multiecuscan.net/Register.aspx
5. Paste or enter the Hardware Key, and enter your forum ID (not required)
6. Click on Buy Now button and you will be redirected to PayPal.
7. After successfull payment you will receive an email with your License Key.
8. Go back to the program, enter the License Key and click Activate.
9. The program will close, and when you start it again it will be REGISTERED.



P.S: I have problems with the hosting and the excessive downloads, so if you don't need the new features in v2.1 then please do not download it.

Regards,
Yani

[mario1979]

when will be a box version of Fiat Ecu Scan?

[EnIgMa]

nice job yani!

[OndraMarkow]

Hi Yani your program is very good .. I use it very much and that's helped me in working with cars, so thank you very much ... just ask to simulate CTRL + F10 in version 2.1 .. Simulation does not work me what it is? Thank you OndraMarkow from Czech Republic

[yani]

Ctrl+F10 works only in REGISTERED version.

Yani

[Alchemy]

hi!

I understand it, the "activation code" is bound to a single "hw pc"
not having a notebook final and having to experiment
then give me a new activation code for a new PC ?

I hope soon to try this sw on my ECU: MJD 6F3.D1 with ELM 327 v1.3a

good work

[topogatto]

Hi,
I hope that you will not need to "Run As Administrator" anymore.

Yes, now works without "Run As Administrator"

Bye
Diego

[Subocean]

Great job!

The only thing that doesn't work - so far - on my laptop are the Parameter Templates. Ctrl.+0-9 key combi doesn't save templates...


...or so I thought - because templates don't show up in the template table. However, they are stored 'invisibly' - by keying any afore stored number, they will come back.


Martin

[dany25360]

Hi! I modified the Board in a Fiat stilo 1.2 16V and we put one of abarth but I give error that I don't have parking sensors you can canceled this with this program ?! Thank you're the best

[EnIgMa]

what's the difference between service interval reset (base) and (comfort)?