Disconnections on 2.1 demo version

[lancialybra]

Hi,

I used the Multiecuscan today, for the 1st time (Version 2.1 demo) on Lancia Lybra 1.8 (pre-EOBD, made 12/1999, Hitachi MPI). I had some disconnections when runs some engine parametres and many diconnection when plot a graph, and I need to connect ECU again all the time. The ABS & Aibag section works very well.

Is this a bug with this Hitachi version or it is usual on demo multiecuscan version?

Keep your good works...

engine_read.jpg (50.14 KiB) Viewed 3863 times

[BR-Scan]

What interface are you using? Try the ELM327, it's much better than the KKL VAG-COM type.

[EnIgMa]

did you noticed any latency warnings?
you can see it on the bottom left corner of the software.

maybe is it.