FAULTY ELM 327 INTERFACES DE-MYSTIFIED (READ HERE)

[Alfaeddy]

Hello Skorchichko

Remove the highlighted in yellow frame resistor (R04)
and your interface can also read the other controllers

Greetings Eddy

2013-06-27 12.52.09 (Custom) markiert.jpg (140.82 KiB) Viewed 5953 times

[sgorchichko]

Hello Skorchichko

Remove the highlighted in yellow frame resistor (R04)
and your interface can also read the other controllers

Greetings Eddy

Thanks a lot, Eddy. I will try tomorrow and let you know the results!

[Alfaeddy]

[quote="Alfaeddy"]Hello Skorchichko

Remove the highlighted in yellow frame resistor (R04)
and your interface can also read the other controllers

Greetings Eddy

Edit: I meant, of course with other controllers CAN Bus controllers

[sgorchichko]

Hello Skorchichko

Remove the highlighted in yellow frame resistor (R04)
and your interface can also read the other controllers

Greetings Eddy

Edit: I meant, of course with other controllers CAN Bus controllers

Should I totally remove the resistor without putting any connection between these pins?

[s130]

Should I totally remove the resistor without putting any connection between these pins?

YES. Just remove the resistor and do not put anything back in its place.

[sgorchichko]

Awesome, it works. I've just cleared the service interval!
Thanks to all of you!!!

[Alfaeddy]

Hello

Nice we can help you


Gruß Eddy

[joseaprieto68]

Thank you very much Yani.

After having a bad time looking for a 560 pF capacitor in my town, I finally had to connect two 270 pF in parallel for an equivalent 540 pF.

Despite this difference it worked perfectly. However I found that conecting to ECU took a long time (1 minute aproximately)

Thanks!

[Scarab]

I have this elm327-usb v3.0 there is some modification to be done to connect to the CAN?

I attach images of the elm327

thanks for the help

[Ziyan]

I have this problem too, I would appreciate some help

2013-07-12 18.28.14.jpg (300.48 KiB) Viewed 5835 times

2013-07-12 18.30.48.jpg (278.22 KiB) Viewed 5835 times