I have just replaced a set of injectors after real problems diagnosing the faults. Fuel pressure was low but engine started and ran. Later it would go into limp mode when the accelerator pressed to move the car. It would rev fine at no load. I replaced the pressure regulator and sensor. Engine would...

This is a an old thread but my problem is exactly what is being discussed. I have a 2009 Panda 1,3 Multijet I have just installed a set of Bosch remanufactured injectors but get the "Incorrect Interface" error when I try to enter the new calibration codes. I have carefully used "I&quo...