Hi,

Can anyone tell me if there is a table of what each of the custom bytes on the custom proxy screen form an Alfa Romeo Stelvio?

Thanks

Frank

Hi, Can you elaborate about the wires? I have checked the power at the connectors and can see power there. I have attached the picture of the connector My understanding is these are the connectors 1– Low beam positive control . 8 – NA. 2 – DRL/side Marker Lamp Positive Control 9 – Vertical Adjustmen...

Hi,

The wiring is the same
the xenon lights work fine.
The LED's do not when when I checked the voltage at the pin it drops when the LEDS are plugged in.

I suspect the BCM is not picking up the changes but this is me having a guess.

Thanks

Frank

Hi, I have been trying to enable Xenons on my Stelvio. I have changed the setting in the MES and successfully run a proxi config. However the DRL and indicators are not working - I have checked the light and it ok and the connector is fine. I can only assume that the change is not taking affect afte...

Hi, I added some paddle shifters to my Alfa stelvio When I tried to do a proxi at the end I am getting a timeout on certain modules. I seem to be able to access the car scan for errors and clear them - but cannot complete the proxi- I am getting a flashing odo. Any suggestions please Thanks Frank