I have an 146 1.6 TS 1998 not starting. There are no warning lights going on, MES can connect to the ECU and shows no errors. It seems that there is no spark and no fuel injection albeit MES can activate the injectors. Timing belt is OK, fuel pump is runnning. There is fuel in the injection rail.......

if the telematic box is this ubigi connect thing, it is working properly.

MES doesn't list that telematic box in the menu with all other ECUs, sure it is supported?

This is what comes after Scan:Scan vehicle for available modules... Engine / ECM UNKNOWN/UNSUPPORTED ISO Code: 00 01 50 73 17 Gearbox / TCM/NCA/NCR (Automatic Transmission) ZF 8HP50/75 Automatic Gearbox ISO Code: 00 0B 50 AA 14 Gearbox / DTCM (Drive Train Control Module) Magna Q4 Transfer Case ISO C...

after telematic box failed
I wrote the old proxi config and did proxi algnment.
It was then shown as OK already.

My question si how to do proxi alignment after changin the proxi config with this failing node?

So that I get it right.
Version 4.6: chnage proxy values for DNA
Perform proxi alignment
Then Version 4.7:
perform proxi alignment again without adapters?

Or is there a way to just write the proxi to this one module with 4.7?

4.6 is able to write to the ABS module and now Telematic node stays Body Computer Node (BCM/NBC): EOL Ok Engine Control Node (ECM/NCM): EOL Ok Dashboard Node (IPC/NQS): EOL Ok Automatic Transmission Node (TCM/NCA/NCR): EOL Ok Gearbox Selector Node (ESM/GSM/NSC): Ok Driver Assistant System Node (DASM...

Used 4.7, will try 4.6
Doesn't it also show timoeut at abs?

IN another thread I wrote about troubles wit my MY2020 Stelvio and my Wifi Module. My OBDprotect dongle arrived today and I was able to connnect and change proxy BUT: I was able to enable race mode and auto high beams. While driving I recognized 2 things: ESC did not switch Off in race mode and when...

Version 4.6 and 4.5 same issue.
So I will try the OBD protect ELM327 cable then

Will try with version 4.6
As the recent 4.7 version,and the in I already have tried with, is described with: fixing issues with proxy alignment on Stelvio models and added new procy configurations
my hope is limited.