Finaly i bought an elm 327with pic 25k80 (lot of them advertise when you know you have to find it). Work fully test, error, scan and proxi alignment. It is with 64 bit windows on 2009 500c. But I doubt multiecuscan have the convertible module option. Or this module have no proxyalignement and no way...

Not in simple 1.4 16v too. I read it's not can bus module. Not sure what Lin is but it is the connection type. Maybe it explain there is no proxy alignment and operation neither.
I need to rule that out cause my boot is not opening even after my softop is back with a new roof ecu.

Bonjourno, My softop is working again with a new roof ecu (new but old stock to go along with my 2009 500c, all the softop motorisation change in 2011= 1500€ if you roof ecu brake up and you don't find an old stock). My boot/trunk/tailgate is now the problem: - It stop working from time to time when...

Windows 64bit is allowed for the ELM327 ? I saw at least one ELM's ad with "'windows 32 bit only"'.

Not good COMMAND: ATZ RESPONSE: COMMAND: ATI RESPONSE: COMMAND: ATE0 RESPONSE: COMMAND: ATL0 RESPONSE: COMMAND: ATH0 RESPONSE: COMMAND: ATSPC RESPONSE: COMMAND: ATS0 RESPONSE: COMMAND: ATCAF0 RESPONSE: COMMAND: ATCFC0 RESPONSE: COMMAND: ATCRA 7B0 RESPONSE: COMMAND: ATSH 7B0 RESPONSE: COMMAND: ATAT1 ...

Tested both side of the 121 ohm resistor close to LM chip (between two pins in the middle on one side of the chip), pin 6 and pin 14 for the plug are connected there. Still read 10Ohm on my cheap multimeter, there come my worry from so OK. The hard pin were not that hard, I cut two of them easily. M...

Hi, I have connected an unmodified wifi ELM to my fiat 500 convertible. From the licenced software, I can access abs for exemple. It's connected. Now I need to access the convertible ecu to reset it and face 2 problems: 1* it is not wired inside but only hard pins an printed board. Can I connect 1 a...

Hi, Unmodified wifi ELM 327 is connected to my licence software: EPS and ABS amoung other are readed. To access the convertible ECU: - It will be easier for me to connect 1 and 9 without cutting 6 and 14. My ELM has no wiring inside, only hard pins and IC. Any advise ? - Strange I found 9,1 Ohm betw...