Thank you for the post!

Yesterday I disconnected the battery for over an hour while I installed some new seats, and after I reconnected it the odometer was no longer flashing.

I’m just happy it’s working out now!

My only issue is that my odometer is still flashing.

Should I have ran a proxy alignment after setting the higher odometer mileage?

Thank you very much!

I have a 2012 US Abarth and installed a 2015 TFT. Going through multiecuscan, ECU mileage reading =92,847.8miles The car has an odometer readout of 97,522miles - why would the ecu mileage reading differ from the actual miles of the car? - I did a test and wrote 97,000miles, but the TFT odometer disp...

I would love to disable the horn beep when I lock my doors.

I had the same issue.

Any chance you figured out the issue?

Is there a setting in the TFT cluster module for hill start assist? I installed a 2015 TFT cluster in my 2012 but lost hill start assist. It's turned on in the menu of the cluster. I updated byte 65 to 60 (which looks much better), engaged the hazard illumination on deceleration, and also disengaged...

I have not used MES to reset my service changes but you can get rid of the light by following this procedure

1- Turn your key to the auxiliary ON position (One turn before start)
2- Fully depress the gas pedal 3 times
3- Turn key to off position

I messaged with bigdaddysrt on fiattech and he said I don't need an Abarth tft, I can setup a pop or lounge tft to work in my abarth with MSE and the proper cables.

Being that he said that and you are saying they're the same part numbers I think you are correct that it comes down to proxy settings.

If someone with a stock TFT gave you a screen shot of their Abarth's custom proxy information, would that help? Then you know which byte information you need entered. I give you guys a lot of credit for doing this. I would love to see you get it all figured out.. You mean change graphics on the fia...

If someone with a stock TFT gave you a screen shot of their Abarth's custom proxy information, would that help? Then you know which byte information you need entered.

I give you guys a lot of credit for doing this. I would love to see you get it all figured out..