Share the other side of the PCB too
Good luck

If you do not remove the resistor you will not be able to connect to CAN BUS controlers. So use a multimeter ( ohmeter ) to check if the resistor is there 120 ohm between CAN BUS pins 6-14. If there is you have to remove the resistor. If there isn't any resistance between OBD2 pins 6-14 ( on your in...

Forget about jumpers. Use adapters especially if you wanna use Proxy Alignament. Jumper just connect together some pins to make the interface comunicate with controlers on other pins the 7 (k-lin) or 6-14(CAN BUS) The best ways is to use adpaters or as me an all-in-one adpater that let you manually ...

Hi
Sure I sent you details from where I got it by Private Message.
Good luck

Hello guys This post is just for information. I bought few months ago this all-in-one adapter. I just wanted to share my experience with you. This all-in-one adapter replace all the colored cable adapters that I used before and I do not need to change cables during the diagnostics. Me I am using an ...

Try MES v2.8R1
See if its working
Good luck

Hi You can check here what controlers need adaptor A3 http://www.multiecuscan.net/SupportedVehiclesList.aspx Then your pics is not such a good. I cannot figure it out where is the rezistor that need to be removed. This is for CAN Bus but as I said you will need adaptor A3 too for controlers on CAN B...

Don't you have a chinese 3 pins adaptors?
All are the same
Take alook here: http://www.autotronic.ch/media/images/fiat-3pin-1.jpg
Good luck

All you need you will find here sir
http://www.multiecuscan.net/ReleaseHistory.aspx
Good luck

- The License is also valid for 1-YEAR FREE UPDATES of the multiecuscan software. After 1 year you can continue to use the software forever, but you will not be able to update it. The price of additional 1-YEAR updates is the same as the regular REGISTERED License price (50 EUR). Check first iof you...