Hello everyone, I wanted to change the chip MCP2515 with a version V1.4 type the PIC18F2580, but this chip is not found in 18 feet to be welded, so I ask you, there is a chip in 18-pin compatible with version V1.4

Hi Luca Rossi Here also again, your board has no bridge resistor I would ask at your first post already are Which vehicle you would like to read? Year of construction? Control? Your interface has no errors I can see Greeting Eddy car fiat punto 1.3mjt 2009 diagnosis engine resistance bridge I had a...

Hi Alfaeddy

here he is now?

Anyway, I wanted to know if you can change the firmware since multiecuscan recognizes him as elm 327 V2.1 and says it is not compatible with elm 327V1.3 (and will not connect to any Canon .......... .)

Hi Alfaeddy
resistance R27 measurement scale 200 ohms = 98.2 .....
What should I lift near the white plug 8 pin?
one marked with a red circle?

Hello Alfaeddy
the R27 was about 100 ohms between pin 6:14, sorry I do not understand what I have to raise more. I'm Italian and I'm using a trans latore

Hello Lucarossi What ELM this is because in the image v1.5? or v2.1? This is the version v2.1 not to change to work with MES can But the v1.5 before, this is to be modified. But I do need a better picture and yet What kind of car and what control you want to read ??? Greeting Eddy I was sold for el...

Good evening, I'm new and I bought two Chinese elm 327 sold for V1.5 and V2.1 result. And 'possible to make them compatible with multiecuscan? http://s17.postimg.org/ulragg433/IMG_4360.jpg http://s18.postimg.org/odidc5sjd/IMG_4359.jpg COMMAND: ATZ RESPONSE: ATZ ELM327 v2.1 > COMMAND: ATI RESPONSE: A...