Alfaeddy wrote:Hello

I mean the large connector that connects the Selespeed unit with the vehicle.



Greeting Eddy

Ok, thanks Eddy, I'll try and find that and give it a clean and make sure it's seated correctly.

Hello Lethal29 With so many errors in the memory I would suggest first after contact problems in the connector (20 pin). The make from time to time problems when the plug too deeply depends in the engine compartment and splash water coming off. In addition, the battery should be charged well. Many ...

I have just been out and taken some more screenshots, and found more errors as per attached. I have also encountered the problem again just after starting the car: Started Car, put into 1st then reverse, and Selespeed warning light flashes and stuck in R gear, then went to N, and not able to change ...

Not yet! Been screenshotting and testing a few things this arvo, and hopefully someone will come along to tell me what I need to check or, ideally, what I need to change to fix it all!

It appears I may have posted this in the wrong forum, so please move if necessary.

Hi All, I'm new here, and have a question about using Multieuscan to diagnose a fault with Selespeed transmission. Basically, the car is sometimes not engaging gear on startup, and occasionally either slipping out of gear while driving or sticking in a gear. I get the Selespeed light flashing, so ha...

multiecuscan 2.0 works well with the Alfa Romeo 156. Diagnostic software displays alot of useful information which then can be used for undertaking certain service and work. The car doctor radio show also strongly recommends performing diagnostics before doing any service. I have to say that I agre...