Hi RogerAvenger!

Don't need any other switch!! Your picture is correct! You only need to remove the black cable from pin4-5 and then solder it to pin3 (airbag)! The switch must be in "3" (airbag) position!! After this mod, you can read the airbag module!

Today I reinstalled the WIN7. Now ELM works perfectly on my notebook. I really don't know what was the problem.

Hi Alfaeddy!
I used this driver from the first times with my first ELM. But only can read the engine ECU nothing more.. It's time to WIN reinstall..
Otherwise today I made a successfull Remote Control programming on Fiat Stilo. So everything is good.

Hello Vmaci!

Same PCB is on the page 104 than yours! The resistor is on the other side, under the white connector 'R04' 121. You only had needed to read back a few pages..

All of my USB driver is installed. In the device manager everything is OK. Haven't got any "(!)" near the hardware.

So Eddy and Others! Listen! You will read an interesting and crazy story about my ELM adapters. I start the story from the beginnings.. I ordered a VAG 409 cable, It had a soldering problems inside, i correct those, and now it works propeprly on my laptop, and my car Punto II. I can read the Engine...

My new cable arrived, and it's working properly.. I'll write down soon what was the problem..

Still waiting for my new ELM cable. It needs to arrive in few days..

Yes you're right, XENON is on the 12 pin.
But my main problem was the Airbag line. Which was soldered to pin 4-5, instead of pin 3! (Red cable)

OK, no problem..
I've ordered a new one. After 2-3 weeks it must be arrive. So i'll come back here again.