hi eddy,
above all thank you very much for your help.
the truth that I have owing of bad luck, jjeje
I ordered a cable kkl, I hope when I get everything working.
I'll tell you like everything went.

thank you very much again for everything.

Greetings.

The other photos.

the second photo corresponds to scanner interface and it says latency very high

Can it be that the three pin cable this bad?
Would there way to check?
or can it be car problem?

thank you very much for your help eddy

Best regards

eddy hello, thank you very much to continue helping me
I changed the latency to "one" like you said and I followed the steps that you have shown me, but still i can not connect.
I am attaching the photos

hello eddy thanks again,
I installed the cable drivers but still does not connect.
I am attaching the hardware configuration, because I do not know how it should be.
my car has 3-pin connector. Could it be that this cable is that bad? Is there any way to know?

thank you very much again
Best regards

thank you very much for answering alfaeddy.
then can i used it to connect the engine ecu?
If so, what would be the settings and drivers?
Best regards

Hi all,
I recently bought a ELM327, but I can not connect to the engine ecu fiat brava 1.9JTD 105hp. FES with all correct test. but still will not let me. I do not know if it configuration problem or the cable.
the cable is this.
greetings and thanks for everything