Hi I am trying to use my sat navigation unit to run Multiscan. It is running Windows Embedded CE V 6.00 It has Bluetooth and usb port. I have installed Fesmobile OK and it runs OK. When I connect my usb/elm 327 interface cable to the cars Ecu and click connect I get the message IO EXCEPTION CHECK PO...

Hi,

When should I use the self adaption reset on Doblo 1.3 multi jet 2008 45,000 miles.

My understanding of it is that it re-adjusts tolerances after wear.

Can the use of this be dangerous.

Perhaps you could explain its function.

Thanks

Hi Yani,
Would I be wrong in assuming that if I wish to connect my Vag-Com 409 cable to --
The abs module then I should select switch1 and switch3 and if I wish to connect to ---
The airbag module then I should select switch 1 and switch 2

Thanks
John

Hi Yani

So if I get a warning bleep when connecting to the abs module its normal.
I might be wrong about the warning message as I was in a hurry to disconnect after hearing the bleeping message.
So its ok to try again.


Thanks
John

Hi Yani, I seem to be getting some very strange results when connecting to my Ecu, I think I am following the instructions properly. I have a VAG KKL 409.2 interface cable with micro dp switches built in (4) It will not work with any of the Doblos modules when none of the little switches are selecte...

HI yani

I have been using Multiecuscan supported vehicles Doblo type119 1.3jtd interface recommendations, but I am not sure this is correct for my march 2008 1.3 dynamic multijet
please would you confirm that Doblo type 119 1.3jtd interface types are the correct ones for the multijet.

Thanks
John

HI, I have Doblo 1.3 multijet 2008 / 3.3 Multiecuscan registered / Elm327 v1.4 said to be modified to solve cheap Chinese cable issue. complete with red/green/ yellow colored converters. I can connect the ELM327 and access the body/dashboard/service modules but cannot access the the airbag and abs m...

Hi
Would be you be able to tell me how often regens should happen and how long should they last.
Thanks
John

Hi, Thank u s130 it was helpful. But my brain cannot understand that the the levels do not give a indication of good average and bad clogging levels, what would be the point of having a measurement with no point of reference, imagine a cooker or a set of scales that had a measurement but no point of...

Hi I have a Doblo 2008 1.3 multi jet diesel. I cannot find any one including Fiat dealers who now what the acceptable DPF clogging level should be for this model. My clogging level is 85 percent and the car runs fine no problems no fault codes. I have heard of cases of Doblos with over 100 percent s...