Check if there is a airbag connection on the cars multiplug. It is possible that the airbags still uses a 3pin connector under the center console.

Thanks Yani for implementing the oil pressure and other parameters on the Selespeed EOL test on the Alfa 156. However the most EOL test failure problems are insufficient oil pressure and low battery voltage. The temperatures on the gearbox and clutch are not realy important. So could you please chan...

It is the rail pressure. The sensor sits at the end of the fuel rail. Is there enough fuel in the tank? (heh-heh! sorry but it happens). Is the cambelt ok? Check for fuel leaks from the high pressure pump to the fuel rail and the pipes from the fuel rail to the injectors. Finally disconnect the fuel...

Hi Yani, Will it be possible to smooth out the graphs. Sampling causes spikes all over on some graphs like oil pressure on a selespeed unit, which can be misleading. Also on RPM & temp readings, which makes it hard to find a intermittent fault. Your software is getting better & better. Congr...

I have tried to open a Alfa ABS unit. You can pry the glued lids off.
However there is not much you can see or repair.
Best solution is to obtain a 2nd hand or new unit.
Dev

Heh-heh! Thats why I could not clear a flashing Odometer on a Alfa 147.
Had to bullshit the customer!

Hi Yani,
I am realy sorry for wasting your time, I think old age brings brainfade.
You are 100% right, Me 2. & 3.1 for the 156 2.5v6
Sorry again.
Regards,
Dev

Hi Yani, I am 99% sure it was there in previous versions of FES. The Alfa 156 2.5 V6 24V from late 02 onwards,(so called facelift) had the Bosch Motronic Me 7.3.1 engine ECU installed. The ECU was mounted on the plennum chamber and the car had a display panel on top of the dashboard centre, combined...

Hi Yani,
In FES v 6.2.1 the The Me 7.3.1 Engine ECU for the Alfa 156 2.5 V6 has dissapeared.
Can you please put it back. I can use the GTA's Me 7.3.1, it gives a ISO code fault, but is usable.
Thanks,
Regards,
Dev

Thank you Yani and everyone who assisted you with your FES software this year.
It is a masterpiece.
A merry Christmas & a very good new year to you all !!
Regards,
Dev