Many thanks, Juggers. I have downloaded the full Multiecuscan program, run it on my car again and it came up with the same P0170 fault, but this time I was able to switch the MIL light off. I will have to see what my son can do for me when I see him again. I may be lucky to catch him on Sunday on hi...

Right Folks. I tried the Multiecuscan using my ELM327 Interface and the program still did not recognise the interface, so I tried another bit of software - EasyOBDII and after finding the correct com port, it gave me the following fault: Stored DTC (S) P0170 - Fuel Trim Malfunction (Bank 1) Pending ...

Yes Mal - Wisbech in Cambs. Hopefully, I can get my son on the job, but as he is working in Evesham at present, so a bit difficult. I did try it all out yesterday evening, but it came back with an error message - Interface not recognised, but I am hoping to give is another try this morning using dif...

Thanks Juggers. Can't get out to run a check at the moment. Bit too dark and looks like we could be in for a downpour any time now

Hi Juggers Many thanks for your reply. My Punto is a 52 plate (2002?) and I have located the connection point. I had a bit of difficulty bending down, but now I know where it is, I can have a go with plugging in my ELM 327 as you correctly mentioned. I think I got confused with the Pennant Number of...

Hi all I have an ELM 274 USB and downloaded the Multiecuscan software, which tells me that the OBD connector is near the steering wheel. OK, excuse me for being a bit stupid, but HOW near the steering wheel? Is it inside the box to the right (On RHD cars) and if so, where? I have had a look around, ...