I've found a guy working for FIAT telling me, that's an software error. The sensor give's the value 15% when air is good. But with the lastest sw version the controll unit gives an error if the value is <20%....

Crap.... never ever FIAT anymore

Ok, then you can try the following: In PROXI settings set Display Type to Matrix/4 lines and do the PROXI alignment again. Also, after finishing with the PROXI alignment, send me a report (from the red Send Report button in Multiecuscan). Hi Yani, i send you the report. I hope you find the reason, ...

Hello Yani,

thank you. I will try it after my holiday.
I've never seen the PROXI - settings you wrote about but i'll look.
I will send you an report from the new dash and the original dash.

Thank you very much in advance

Hello Yani,

thank you for your reply.

The original was not-dot-matrix (the less nice) with cornering light / s&s / GSI.
Yes i did the PROXY alignment. Nothing changed

/EDIT

I missed to say:
The dash was already mounted on another bravo an aligned.

*bump*

No answers? To diffculte question or no good enough explained?

YANI i count on your knowledge

Hello, after changing the original dashboard with an dot-matrix-dash i miss the S&S symbols, the GSI - symbol and the cornerning light menu. Is there any possibility to activate it these functions? Is there any possbility to "reset" the dash to bring it back to the "brandnew"...

Hello, i've got the problem, with the climate controll and the start&stop system After the engine stopped, the ventilation speed speed of the climate isn't adjusted by the automatic anymore. I've to chose if to have the comfort of the automatic system and don't use the start&stop system or u...

Oh sorry,


It's a Fiat Bravo, year 2012. It appears sporadically and no error message is placed on the dashboard.
I can cancel the error and sometimes after 2 weeks it reappears in the body. Normal using, nothing special what i can detect as cause for the error.

Hi,

the error was placed in the bodycomputer.
The error code is all i got

Hi,

anybody knows, how to find out what causes the error "B1004 - A-Bus serial line high" ?