Good afternoon all.
Can anyone please tell me if they are managing to calibrate these Mito sensors?
Have you read this Yani?
Thanks.

Bump.......

(Have same issue/comment)

Hi Yani.
Torque sensor calibration was not possible on 5 Mitos whose sensors I replaced over the past weeks.
All had VDC.
Steering POSITION calibration was successful on all.
Can you please help?
Thanks & Regards
Ralph

Yani.
Although I use your great program continuously, I've since never managed to connect with this or any other 3 wire connector airbag ecu.
Can anyone here give me step to step instructions on how they successfully connect?
Thanks & Regards
Ralph

Hi. I connected successfully from the 3pin connector in the battery compartment this morning. I still have to get accustomed to the functions and parameters of this module as the commands I gave failed. This particular car has a fault in the 5th bow sensors and some faults shown were without a descr...

Hi.
I made this post before noticing that version 2.2 is out.
I'll try it out when I'll have another 916 spider at the workshop and revert.
Thanks
Ralph

The 939 spider is completely different to the 916.
Thanks anyway.

Any ideas Yani?
I did send reports when failing to connect.
Ralph

Has anybody managed to connect to this module? When I scan DTC with KL and purple connector from the the dash OBD connector only the engine ecu is seen. When I scan DTC at the 3 pin connector in the battery compartment with or without the purple connector the Dura hood ecu is visible but impossible ...

Any plans to support this troublesome module Yani?
Thanks
Ralph

Hi Yani.
I tried several times to connect to the Continental MK60EC ABS of a 1.4 Giulietta this morning unsuccessfully.
I have sent reports.
Thanks & BR
Ralph