Thank you.

In replacement for the need to use adapter cable no 3(ELM C19), is it safe to modify an elm327 by linking can pins this way:
6 connected to both 6 and 1 and pin
and
14 connected to both 14 and 9
?


For pin 7 to 12 there is a jumper already.

Hi, As usual the Marelli climate control on Stilo is very buggy. Now it blows cold on left side and hot on the right side. The errors learned are: 1: B1908 - Right mix motor feedback 2: B1904 - Left mixing actuator 3: B1909 - Right mixing actuator 4: B1927 - Pollution sensor The errors are not prese...

I have a suggestion. Could you please make an option to save the report as text for later sending? Usually in the car is no internet connection.
If so, you could put on the website a form where later, to upload the saved text file, or you can specify the email address were the text can be sent.

I have tried to send report, but the internet connection was poor and I don't think any of the reports were sent. I have a suggestion. Could you please make an option to save the report as text for later sending? Usually in the car is no internet connection. Here is the test output, run from the Set...

As I remember all tests were ok. I will try again in the morning and post the results.

I have an elm327 modified with switch. I can run the test on FES at 38400baud and everything is OK. On my Stilo 1.9 JTD 115, I can connect to ABS/ESP on pin 1, Engine on pin 7, Steering on pin 9. I also connected pins 12 and 13 with switch. I am unable to connect to Body, dashboard, parking controll...

I have a stilo 1.9JTD, 115HP. I use an elm interface. The settings are 9600bps, 8/none/1none, Latency 1ms. If i select ELM327 v1.3+ and run Test button I receive ok on all tests. I have connected with switch pins 1,3,7,9,11,12. I can connect to ABS, Engine, Steering. I cannot connect to Visteon Dash...